Wood Plastic Composite (WPC) Manufacturer in China
Tel: +86(752) 2222-845 Mobile: +86-139-2288-7311
info@www.protechwood.com Contact us at any time
Building 1, Huamao Building, Wenchang Road 1, Huizhou, Guangdong, China
Monday - Saturday 08:30-18:00

Blog Posts

May 12, 2015

Protechwood – How To Install Shutters

There are quite few improvements that you can make to your household that will have huge enhancements to its curbside attraction. Shutters close to your windows not only makes a wide advancement in appears but also don’t cost a fortune and they are rather straightforward to put in. Down below is a action by action tutorial and a video clip at the bottom on how to put in shutters and the instruments important to entire the career. The exterior complete of this dwelling is brick but the shutters come with hardware for wood buildings also. The additional hardware that the shutters will come with will be 2 one/2″ screws and plastic screw head addresses.

Initially you will want to make a decision what variety shutter to put in. We have decided on the 50/50 equal raised panel shutters with wood grain. They are black plastic and come with all hardware necessary to put in on masonry or wood buildings.

Upcoming, select which windows to put in shutters close to. Measure the heights and make guaranteed there will be almost nothing in the way of the shutters.

Ahead of you commence installing the shutters you will have to have a hammer, hammer drill, 3/sixteen” wood/plastic drill bit, 3/sixteen” masonry drill bit, protection glasses and a ladder.

I like to drill into the mortar joints simply because they are gentle to drill into than brick.

Set the 3/sixteen” plastic/wood bit on your drill. Maintain the shutter in area and mark with you drill wherever the mortar joints are on the shutter. You will be marking two at the leading, two at the bottom and two in the centre.

At the time you have your gap locations marked you can clear away the shutter and drill by means of the shutter.

At the time you have your shutter holes drilled, change bits on your drill to the 3/sixteen” masonry bit.

Maintain your shutter in area and place the bit by means of the shutter and drill into the mortar joint roughly 2 one/2″ deep. Repeat for all holes.

Now get your 6 masonry spikes that came with the shutters and thrust them into the shutter. With your hammer tap the spikes all the way into the brick right up until the spike is flush with the surface area of the shutter. Repeat these techniques for the other side of the window. Congratulations, you have completed a person window!

Repeat these techniques for all other windows you have picked. If your dwelling is a wood framework you will want to use the 2 one/2″ screws and the plastic caps.

With your shutter in area, use a Phillips head bit on your drill. Set the plastic cap loop in excess of the screw and run the screw by means of the shutter into the wood right up until the screw is flush with the surface area. At the time the screw is flush, fold the screw cap in excess of the head of the screw and snap the screw cap on and your carried out. Repeat this system for all shutters.

Now you can stand back again and admire what an advancement shutters make on your beautiful household.

Verify out this full size video clip for more in depth info.

http://www.youtube.com/check out?v=Nn841LGTMug

Resource by Protechwood

All Posts , , , , , , , , , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Contact Us
Building 1, Huamao Building, Wenchang Road 1, Huizhou, Guangdong, China
+86(752) 2222-845
+86-1392-2887-311